Introduction and installation of Field fence

Field fence are both Dutch nets and subway screens. It is mainly made of high-quality iron wire welded, and the PVC or PE and PP powders are vulcanized and coated on the surface, which has strong adhesion, good corrosion resistance and bright color.

Chinese name Breeding fence net width 0.5m-2.5m; use for breeding, animal husbandry, etc. Material iron wire, aluminum alloy wire, etc.

Breeding fence material PVC wire, stainless steel wire, high quality low carbon steel wire, iron wire, aluminum alloy wire, etc.

Breeding fence mesh specifications: 1. Net width: 0.5m-2.5m; 2. (wire diameter) after coating: 1.0-3.0 (mm). 3. Aperture: 50*50 50*100 (mm).

Breeding fence network features: beautiful and generous, sturdy and durable, easy to transport and install, with good filtration precision and high load strength. The use of high-efficiency dip-coating has greatly increased the age of fencing nets.

Breeding fence net use: It is applied to the protection of highways, railways, airports, enclosures, fences, residential quarters, port terminals, breeding, animal husbandry, etc.

The installation of the culture fence network has a fixed installation mode with the ordinary fence network. It is generally installed according to the type of culture fence network used and the local topography and geological conditions. It has many methods and has certain skills. Searching.

1. Installation of the column The breeding fence network is roughly divided into two types: pre-buried installation and flanged installation. In mountain forests, fields, orchards, etc., the installation of the fence net is generally carried out by means of pre-buried column installation, which is also the method adopted in most cases. In addition, there is a flange type installation, which is often done on the concrete floor or in advance with a concrete base. This method is less. 2. Installation of the hanging net The breeding fence network has different installation methods depending on the mesh. The network type can be divided into three types: net roll, set frame net, and sheet wire mesh. The net roll can be installed with a special buckle or bundled directly with wire. Pay attention to tightening and then fixing, starting from one end in turn, the binding position is generally required at the beginning and the end, the middle position is not less than one, it is recommended to set one at about 70 cm.

In this way, there are Dutch nets, chain link nets, steel mesh, welded wire mesh, and grassland nets.

In addition, there is also a set of frame net installation, this installation is also very simple, as long as the connector and the frame net are connected and fixed by the connecting member, it has a special ear to connect. This type of installation is available, network, and so on. The sheet-like wire mesh installation is the third type of installation, which can be directly attached to the column with a wire or a special card. There are several types of welded mesh, Meg mesh and steel mesh used in this installation.